11. ATTACH THE HGA TO THE SPUN BUS.
View the whole assembled model
- Set the spacecraft right side up, supported in a beverage glass, or by some other means. The HGA SUPPORT is the cylinder in the center of the SPUN BUS.
- Apply glue to the top of the HGA SUPPORT.
- On the bottom of the HGA is the BUS SUNSHADE. Locate a white U-shaped mark near the edge on the bottom. This will align directly over the STAR SCANNER (marked G) on the SPUN BUS.
- Set the HGA down on the HGA SUPPORT with the U-shaped mark aligned correctly. Center the HGA by observing the white lines on the bottom of the BUS SUNSHADE as they relate to the HGA SUPPORT.
| CONTINUE |